Check the heat setting on both.
Electric immersion heater not working.
The first and most common cause for electric heater not working or turning on is problem with the.
Watching this video you will know how to test immersion he.
Quick presentation how to find faults in broken immersion heater immersion heater not working.
The following are the causes and solutions for electric heater not working.
Plumber fittied new immersion heater and since then the water doesnt get fully hot or after the 1st bath the water wont heat up enough till the next day.
All to check why newly fitted immersion heaters were not working properly.
Replacement thermostats are inexpensive and easy to fit without needing to drain the water.
Every single one i go to i find that the plumber has turned thermostat up to the max trying to fix the problem causing cut out to kick in.
In this case the problem is most likely with the immersion heater and its built in thermostat.
In some places where they do use gas and the immersion heater is possibly because the immersion is left on at all time costing more on the electricity bill.
Its always the same thing.
This is how it.
It is not recommended that you attempt to address this problem on your own.
In this case electricity is constantly required to keep the tank hot.
However this is an extremely expensive and inefficient way of using the device.
Remove the access panel insulation and plastic safety guard from each heating element on the water heater.
If you have an electric immersion water heater and the heater suddenly stops working or the water is scalding hot the chances are that the thermostat has failed.
Of course we re also happy to be of service at the first sign of trouble as well.
The other problem why cylinder immersion heaters go before its time is the high amount of use specially where there is no gas in the area and the home only uses electric.
Instead get in touch with easy flow and we will get you back up and running in no time.
Turn off the power to the water heater in the service panel.
Test the wires to confirm the power is off using a non contact voltage tester.